The examples of analysing pulse generator and pulse shaper by the method are also introduced. 文中给出了使用该方法分析脉冲产生电路和脉冲整形电路的实例。
Application of Pulse Shaper in Over-loading Test for Initiator 波形整形器在火工品高过载试验中的应用
Control of flexible satellite attitude maneuver using pulse modulated input shaper 输入成型在卫星喷气姿态机动控制中的应用
The design methods of Ultra-wideband pulse shaper are analyzed at present. Its advantages and disadvantages are investigated. This is helpful to pulse design. 本文较为系统地研究了目前超宽带系统中脉冲波形的几种设计方法,分析了各种方法的优点和缺点,对超宽带系统脉冲的设计和优化有一定指导意义。
When impact compression test is exerted, the pulse shaper has been used to regulate the incidence wave, so that the stress gradient will not be significantly high and the results is acceptable. 在进行冲击压缩实验时采用波形整形器调整入射脉冲,从而使得试件内的应力梯度不致过大,取得了较好的效果。
An All-Optical Pulse Shaper Based on Nonlinear Optical Loop Mirror 基于光纤环形镜的全光脉冲整形器
Pulse shaper technique was also used to improve the stress equilibrium in the specimen. 在试验装置中还运用了加载整形技术以改善试件中的应力均匀性。
Control pulse is coupled into this pulse shaper by wavelength division multiplexer. Nonlinear phase shift of signal laser is induced by control pulse because of cross phase modulation. 该全光脉冲整形器利用波分复用器将控制光脉冲引入光纤环形镜中,控制光脉冲由于交叉相位调制在信号光上产生了非线性附加相移。
Temporal Aberrations of Ultrashort Pulse Due to the Misalignment of Grating Pair Pulse Shaper in Ultrahigh Power Laser System 超高亮度激光系统中光栅对脉冲整形器失调对输出脉冲时间特性的影响
According to the method of pulse shaper designing, the specimens are loaded under constant strain rate easily. 另外,通过整形器的合理设计,可以很方便地获得常应变率加载。
Signal laser interferes in fiber coupler, then shaped signal pulse transmits from output port of this pulse shaper. Signal pulse ′ s waveform is determined by the profile of the nonlinear phase shift. 信号光在耦合器中发生干涉,经过整形的信号光脉冲从脉冲整形器的出射端出射,信号脉冲的波形由非线性附加相移的波形决定。
Geometric and material parameters of pulse shaper were adjusted and researched on effect of dynamic behavior in measuring dynamic properties of cylindric cement mortar. 通过调整脉冲整形器的几何及材料参数,研究这些参数对于圆柱形水泥砂浆试件动态性能测试中的影响。